1210 Hydro won't move
 

I have been slowly getting the 1210 I won off ebay back together. The other day I was mowing to see how it did. I started to hear pining from underneath. I shut it down and used a fork lift to pick up the rear to tow it back to the garage. I found the rear drive shaft bolts were broken. The nuts weren't lock nuts so I thought they just backed off and that's how the bolts got broken. So I replaced everything and now it won't move. I move the lever forward and back and no sound from the hydro. What else did I break beside the drive shaft bolts?

Probably punctured the filter. Very common when a driveline breaks. Pull the filter, I bet you find a gouge in it.

Also, check the Spirol Pin on the Coupler to the Hydro Unit input shaft. That pin may have broken too.

It was the filter. I had picked up a new one to do a fluid change in the trans anyway. Thanks for the help.

Nailed it. :High5: