127 transmission
 

Hi everyone new here , can any one help me find out how to adjust my speed control on the 127 it creeps in "N" and it will not stay at 1 speed ,it kicks into wide open without touching anything all I can find in videos is for the 129 which has a removable tunnel the 127 doesn't come off,the handle moves very freely I would think it should have some sort of friction on it.All help will help a lot because you can mow with it like this ,all I did was rewire and paint it and change the filter and fluid ,I don't know how it was before since I just got it and it didn't run before THANK YOU ALL.

Manual section
 

Look in the manual section

Welcome to OCC! Good luck with your 127.

If you have or suspect that you have trunnion problems with your Cub Cadet hydro, start by going here.
http://cubfaq.com/hydrolurch.html

And then here.
http://cubfaq.com/trunionrepair.html

More information here.
http://www.onlycubcadets.net/forum/s...ead.php?t=4635

There is a lot of good debate here.
http://www.onlycubcadets.net/forum/s...ead.php?t=5495

After you have fixed your trunnion your forward-reverse lever and foot pedal may be out of wack, so go here.
http://cubfaq.com/neutraladjust.html

Personally, I see no need to add extra metal pieces to the square hole, unless the ends are worn crooked. I have never had this problem with any that I have fixed. So I simply weld the slots in the corners and then file them back square again.

This is the "stock" information that I post for this question IIRC someone said that one of the links is dead.

To preform these repairs the transmission and rear end must be removed from a Narrow Frame tractor.

Welcome to OCC!