Cat 0 Hitch
 

I figured I would place the drawings of my cat 0 hitch in this section. The install post is here.

This is the lower lift arm; two are needed. Remember when you drill the hole for the lift link to flip the second arm first so you have a mirrored set otherwise you'll have 2 left arms!

Attachment 49086

This is the lift link, two are needed. I used left over chrome moly cut offs for the tube, but an upsized mild steel would work just as well.

Attachment 49087

This is the rock shaft. I added a grease zerk to the top of mine, but I think it is optional as long as you grease it during assembly.

Attachment 49090Attachment 49091

I will update this post as I complete more sketches. If you have any questions, I will try to answer them.

Bill

Thank You!