New Headlights with improvisng
 

I thought I'd share this with you guys. I got a set of headlights that were for the 70/100 Cubs and I thought I'd make it fit in my 125 tractor.

Attachment 43905

Some little improvising and with the help of my dad (he's got the machinist lathe) we made a set of brackets and threaded spacers to bolt in the headlights the same way the cover plate bolts into the tractor grill housing.

Attachment 43914

The headlights fit onto the tractor perfectly! I haven't wired this to the tractor yet, but I will as soon as I figure out where the damn switch should go! Anybody?

Attachment 43912

I suppose I should wash the tractor!:bigthink:

There is a hole on the left side of the dash tower that is made for the switch.
Nice looking 125 when did you get it?

Nice job on the hdlts!

Nice 125! Cant wait to get mine running once I'm done with the engine.

The headlights look good!

nice job:beerchug:

Right here


http://img.photobucket.com/albums/v7...9.jpg~original

The lights look factory very nice job on them. Everyone's input on where the switch goes is spot on.

Wow!! That is a very nice job on modifying your headlights without affecting the original equipment!!! Here's to a job well done and also to American engineering!!!:beerchug::IH Trusted Hand:

Cub Cadet 123