Removal and Re installation of 3 pin driver pushing?
 

Does this need to be pressed in/pressed out? Just trying to figure out if I need to take this over to my dads to use his shop press or if i can knock it out at home. This is for a 104

Mine came out quite easily. find a socket from your socket set that is just a hair smaller than the driver disk bore, place it over the bushing and give it a tap. Should come right out.

Thats what I was thinking while I was sitting here at work. Good to know that that should work. Getting the new one in should be just as easy?

yes. should go in easily. Mine was snug but not difficult to remove/install.

Same here on a 3 pin driver on our 102. It is snug but not very hard to tap out.