Only Cub Cadets

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)
-   Implements and Attachments (https://www.onlycubcadets.net/forum/forumdisplay.php?f=16)
-   -   Is a 12" Brinly plow too much for my 126? (https://www.onlycubcadets.net/forum/showthread.php?t=23172)

Tool Maker 03-10-2013 11:02 PM

Is a 12" Brinly plow too much for my 126?
 
I bought a plow off an ole boy a year or so ago and I "thought" I knew how to measure it and I thought it was a 10" plow. But after goofing off online tonight I realize it is 12". Is that gonna be to much for my 126?

Tool Maker 03-10-2013 11:57 PM

Sorry meant to say moldboard plow in the title :beerchug:

R Bedell 03-11-2013 06:23 AM

There are a lot of variables, to include how deep the plow goes and type of soil.

IH Cub Cadet 03-11-2013 10:30 AM

I cannot imagine the 12 inch plow being to much for your 126. From what I've seen, typically the 12 inch plows were offered for 3 point hitch tractors vs sleeve hitch type - but the tranny in your 126 is no less in strength than those used with a 3 point hitch. BTW, when I say three point hitch, I'm talking about tractor cat 0 or similar vs sleeve hitch.

I'd say the two things you will need to watch out for are enough weight to keep the wheels from spinning and not stalling your engine during a hard pull, which might mean 1st gear plowing vs 2nd gear.

I've got a 126 that I'm putting back in working order and will moldboard plow with it to - at some point.

Good luck,
Bill

mmzullo 03-11-2013 10:41 AM

I pull a 10 inch behind my 70 with no problems. Again what everyone said above are the factors. Traction and weight are key. Engine is more then enough.

Donovan M. 03-11-2013 12:35 PM

My cub cadet 100 has a 12hp kohler( same as your 126) can pull my 12inch brinly with no problem.

lukeott 03-12-2013 03:45 PM

Running Your Plow
 
Starting is most important. When I'm going to plow, I'll run 2 or 3 cuts at the ends. This way when you go to start your rows, you'll have loose soil to start in and your ends will be neat. I think it helps.

CADplans 03-12-2013 04:46 PM

The part of Virginia where you live has as much to do with it as anything.

Rocky Mount VA and south has such heavy clay, many "garden spots" could stop a Super pulling a 12" plow.

I have so much organic matter in my garden, your 126 could pull two 12" bottoms eight inches deep.

Probably the only way to find out is to try it!! :bigthink:

cmatthew 03-13-2013 02:47 PM

yup just give her a go.
i have a ten inch plow on my 12hp 123 and the ground here is such heavy clay that the first plowing was horrible. with ags and weight too. just had to keep hammering away at it. add lots of composte through the year and cultivate often. next year wont be bad at all. i made my rows wide enough for the tractor to go thru with full grown plants. good luck


All times are GMT -4. The time now is 06:46 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.