I need a measurement
 

If someone has a QL engine cradle lying around, could you get me the ID of the ISO mount hole and the thickness of the cradle at that point. Also I need the thickness of the bottom ISO rubber piece. I am trying to get some solid mounts made from Jeff in PA and don't have any available parts to measure myself.

DWayne will that 1650 parts tractor I have get you the right measurements?? If so Ill try to measure it or you are welcome to come get what you need

Yeah, it has the same engine cradle as the other QL's.

http://img.photobucket.com/albums/v7...GFU/bump-1.gif

Anybody have measurements?

Jeff, I am working on something at the moment, might take another week or so. If it goes thru, I'll send you one so you can use it to measure and be able to make some in the future.

DWayne can I mail Jeff one side of mine and it work? If so jeff give me you addess and ill mail. Ill try to upload pics in the morning. Im working this week and not had much free time.

The hole is 3/8" and the thickness at the hole is 1/4" as best as I can tell. I dont have the rubber mounts to give you that measurement

That sounds good.

PM sent with my email address

Jeff