scrape blade super cub
 

I see a lot of four foot scrape blades around here for sale cheap. They are all for cat 1 tractors. Is there a reason they couldn't be changed over to a cat 0 for a super to pull? I can do the fabrication that would be invloved.
My thought is the blade would be to tall? Also to wide, but that would be an easy fix with a torch.
Any thoughts?

The more beer you drink...........................:beer2:

I would be concerned with how heavy it is

i bought a cat1 5ft for my it works good i just had to change pins that were weld on so i cut and welded new ones on some bolt on you can just get new pins

Cub 149, since your going to be fabricating how about a grader blade to go under the center of your cub. Guy's that have them like the way you can work the ground compared to the front mount, I guess it's all what you like but I have been playing with the idea myself to build one. This one in the picture is one that got away a couple of years ago...........:Boohoo:

Another thought, these box scrapers are not all that complicated either, since your building one you could make it as wide as you wanted. I have a rear blade I use on my 1650 and I like the box scraper way better, again all what turns you on :drool2:

I hope you can see the pictures, I have seen them converted to work on a 982's cat zero 3 pt.