Only Cub Cadets

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)
-   IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)
-   -   Front Axle Rebuild Question (https://www.onlycubcadets.net/forum/showthread.php?t=17499)

rickv1957 04-28-2012 02:02 PM

Front Axle Rebuild Question
 
Hello,
My front axle has alot of play front to back. I have my 149 all tore apart and thought this would be a good time to fix it. I was going to replace the pin with a grade 8 3/4" bolt. I have the bolt in there and just the oil pan in place and will have clearance between the head and oil pan.However, when I place my mule drive on I would only have about a 1/4" clearance between the mule drive and the front of the axle. So I would have to cut the jam nut to 1/4" or less, I think that would be too thin. What are you guys opinons on this? Thank's again for all your help. This is my first IH Cub.

CADplans 04-28-2012 02:13 PM

I use the bolt!!!,,,,,,,,,,,,,,,,But,,,,,,,,,,,,,,,,Just to bend the steel until the clearance is gone!!

After bending, put the original pin back in.

Most of the slop of a CC steering system will be found in the pinion pin inside the steering box. Be sure to reshape that pin.


All times are GMT -4. The time now is 06:53 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.