Implement lift bar wf
 

Looking for a diagram. I can not find one so. I'm going to make one. Can anyone please help with measurements? It is the bar from lift handle to the sleeve hitch with a little bend in it. Thanks I am sorry it is a 108 wide frame

It would help to know what model of tractor you are referencing..??

Alexander/is the lift on a Quietline series or 82 or which one? heres the Quietline measurements, a member here gave them to me.

It is a 108 I am new at this . Everthing is clear but the 3/4 holes on the end how close are they to the end Thanks bocephus

dont forget about the bushings for the 3/4" hole , to take it down to the 1/2" bolt that holds it on. Jeff in Pa is making them for me.

HAY Look ,,,, my first helpful post.....

If that bar is for the quietline i need one. I cannot make out the dimensions. Is there a clearer picture out there? There is also a block with a round boss and 2 threaded holes too also correct? Any drawing for that? I have a 1650 that i need to put a lift on. So I need the rear piece that is cast. I would like to make it but I have nothing for reference right now to build it off of. I have a waterjet that I can plug in the dimensions and have that bar wacked out quickly. So there is a bushing that needs to be made also? Is the bushing steel, oil-lite, bronze? Which hole does it go into?

Hey that's my drawing!:ThumbsUp::ThumbsUp:
Here's a closer look.