Worked on the chicken O today
 

Since this was missing the spindles and having home made ones . I decied to make a narrow frontend on it .
so hear's the pic's of it .
http://i227.photobucket.com/albums/d...ountend001.jpg
http://i227.photobucket.com/albums/d...nders001-1.jpg
http://i227.photobucket.com/albums/d...nders002-1.jpg
http://i227.photobucket.com/albums/d...fenders003.jpg

Great idea and pics! Looks to be a fun project.:beerchug:

Nice job, Denny! :beerchug:

narrow front
 

Denny if you would not mind snapping a few more pictures I would like to look at the details like where the vertical rod comes up into the frame. I like the concept and it looks reasonable by design. I have a frame that has had the pivot area modified by a PO and would make a good candidate for a tricycle front end. Not that I need another project right now!
Regards,
Chris

Denny,

That looks awesome :ThumbsUp:

But I thought the bottom of the wheels are supposed to be toed in a little.

Good point Jed, actually, toe'd in a lot from what I've seen.

Here is a pic......

Looks like a job for,

"AcetyleneTorchMan"!!!


:biggrin2:

Heres some more pictures will get betters ones when i take it off to get the toe in
http://i227.photobucket.com/albums/d...rontend001.jpg

http://i227.photobucket.com/albums/d...rontend002.jpg

http://i227.photobucket.com/albums/d...rontend003.jpg
this will be made differnt
http://i227.photobucket.com/albums/d...rontend004.jpg
http://i227.photobucket.com/albums/d...rontend005.jpg
http://i227.photobucket.com/albums/d...rontend006.jpg
Will use hydralic press to get toe in
http://i227.photobucket.com/albums/d...rontend007.jpg
http://i227.photobucket.com/albums/d...rontend008.jpg