1730 governor spring
2 Attachment(s)
I put on a new carb. Everything seems to work fine. But there is this spring that I’m not sure if I put back in properly. You will see in the photo, the green arrow is correct, but the other end, the red arrow does not seem to be connected to anything. Any ideas ?
|
Appears to be some sort of torsion spring and I think it is p/n KH-52-089-08. Look that up and see what you think. I could be wrong, but maybe that will give you a starting point.
Any chance you can take another picture of the end that isn't connected to anything? Is that "loose" end bent or does it have a foot on it? And this might be a good question to post in the LT section. You will likely get more responses there. |
All times are GMT -4. The time now is 05:27 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.