Flat head converted to overhead valve
4 Attachment(s)
This pulling engine is an aftermarket flathead Jones block . It is a heavier built block modeled after a Kohler K series that uses K series type parts. We turned this into an overhead valve engine using an Oldsmobile 455 head with roller rockers and other aftermarket parts inside to end up at 53 cubic inches and 13.5 compression
Attachment 107328 |
2 Attachment(s)
More photos
|
4 Attachment(s)
Couple more
|
Very cool. :beerchug:
|
1 Attachment(s)
Quote:
Thanks. I started with the Stromberg 2 barrel on gas but eventually changed it to a 44 Mikuni side draft on Methanol. |
that is impressive. why cut up the head though, would it not be easier to build a custom head, or is that not allowed in the rules?
|
Quote:
|
1 Attachment(s)
Intake is 2.15 pretty good flowing head to.
|
cool. its amazing what you can make work!
|
This is so cool! I would love to hear it run
|
All times are GMT -4. The time now is 02:50 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.