76 cadet question
 

About a year ago I acquired a 76 cub cadet with stars and stripes. I want to use it for a buggy at the tractor shows. I need to put a utility box on it. I see where one was offered by Cub Cadet. I'm wanting to make one and install it and I'm thinking I might as well make it look original as much as I can. I can see how it goes on the tractor. What I don't have are any measurements. I'm wondering if someone could give me the measurements and bolt sizes that they used from the factory. I've enclosed a drawing, and a better photo of it can be found at PartsTree under cub cadet model 76 diagrams.

I've left a blank space to put the measurements in inches. Did they actually drill holes in the back of the 76. It looks to me that it would have one more hole in the drawbar and two in the back. However, I don't know if I want to drill holes in it. I would also need the thickness of the add on drawbar. I would be thankful if someone could give me this information.

Thanks, Fred B

PartsTree diagram uploaded from my computer to help clarify

https://www.onlycubcadets.net/forum/...1&d=1679612945


I'm sorry but so far I have been unable to post the images that will explain
what I need. I have images, I just need the sizes - top, bottom, width, length in inches.

Is this what you are looking for ??

Thank you Roland. This is what I was looking for. Fred