Magnum Governor Gear
1 Attachment(s)
Working on a M-20. I have it torn down. I did look in the M18-M20 Service Manual and could not find the data I was looking for.
(A) What is the factory "bore" of the Governor Gear ? (B) What is the factory pin (shaft) diameter for the Governor Gear ? The Governor gear seems "sloppy". I don't think that is correct. I don't know if one, or both items, are worn. |
dimensions
R. Bedell, I gave a look myself , no numbers. If new parts aren't in the mix. I would put a small brass bushing in gear, if there is any meat left. The shaft you can tell if there is wear. If need be make a new one.
|
Since the gear is Plastic (Composite), I am guessing this would take the wear, as opposed to the steel shaft.
:bigthink: |
All times are GMT -4. The time now is 10:54 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.