190-207-100 Cub Cadet Rear Hitch Plate
 

Anybody Have a Rear Hitch Plate for a 207 3 point Hitch ?

Reason I ask Looking for someone to trace a Pattern of the Holes of that hitch Plate so finsruskw Can turn a standard 3000 series Hitch Plate into a 207 3 Point Hitch Plate

Like this? On my 3185.

Yes that what were Looking for :)

Let me know what details you need. I"M assuming the cylinder cutout and rock shaft bolt hole positions are what you are primarily interested in. I'm not looking to disassemble my hitch to trace, but it is on the todo list this summer to fix the leaky final drive..

I think he will need the hydro release lever slot position too because it is different on the 365 hitch and original.

This is what I have

MSS7120 I Let finsruskw ask the questions as he is the One Fabricating it Better if I stay Out of It

Other Then To show we Need the Placement of the Rocker shaft Bracket Holes The Hydraulic cylinder Cut Out and The Hydraulic cylinder Frame Front Bolt Hole Locations which I used Dark red for

I suspect the hydro release hole will be ok. I removed the rear weights I had for a more direct view.

Please send a PM with your email and I will get you more higher resolution photos.

Edit: I just sent a PM to finsruskw and sergeant. Please respond with your email and I will send you a google link with photos and measurements.

Looks like a triangle between the 2 upper center bolts and the top bolt of either support bracket would provide what's needed for the 4 bracket holes as I already have the 2 upper center holes.

Got the pic's!

What's the O.D. of the cylinder?

Is your tape measure sitting on the hutch plate in the one pic?

Cyl OD is 2 1/2 inches and the width of the opening is 3 inches. I hooked the tab of the tape on the outer edge of the perimeter flange. From the outer wall of the flange to the far edge of the opening is 3 3/4 inches.

Hard to measure these things with all the hardware in the way. The upper bolt on the rock shaft holder is just above the side mounting hole. The nuts on the back side almost hit. Just a bit of clearance that I can feel with my finger.

Not sure what you mean by hutch plate?

I know He'll need the Hole for the Bolt circled In Red

Is that a 3/8" bolt as well?

TYPO!!
Hitch plate!!
I'm old!! HaHa! and did not do well in typing 101 back in '59.
The Chick that sat directly across from me was....shall I say...rather well endowed!!!!

The bolt below the cylinder is smaller than the upper bolts.

Jeff,

I need the distance from outside to outside of the outside lift arms on your rock shaft to correctly place the holes for the two hangers I made you earlier. Easy enough to get, just stretch a tape across them.

I'll get that for you later this morning, 11 May.

Did you get this figured out?

I think I have a 207 hitch coming. David, did you ever get this completed? Here is a pic of the hitch.
Attachment 110897