Cub Cadet 102
 

I just picked it up. It came with a front loader, 3 point, Tiller, and Grader Box.

That is sweet! I found a 102 and counted myself lucky that it has a snow thrower and creeper gear! Man that's sweet! Someday I'll stumble upon one with a loader!

That's got some serious mods! All homemade.

Hey, seriously...... get the plug wire off the fuel tank before running it. A nick in that plug wire and it'll be a toasty tractor instead of a cool looking one. :beerchug:

there you go sucking the fun right out of everything.:biggrin2:

I'm da party pooper.

Attachment 60367


Like my selfie? Just took it.:bigeyes:

:biggrin2:

What drives the rear ad-on PTO?

Front pto I will get some pics.

A belt drive the rear pto from the front

Cleaned the carb and sediment bowl but now it shot flames out carb when trying to start it

Better work on it some more..... hehe.

If you don't know how long it's been since it ran, I'd pull the head, tune it up, clean fuel system, change all oils and filters........

Why do guys always skip these steps..... :angry:

Thought about pulling the head today but I didn't want to until I get a new head gasket.
We was hoping to get running enough so we didn't have to push into the yard the choke lever on carb broke how are the aftermarket carbs ?

Aftermarket carbs are fine. Just braze the shaft, or weld it.

Thanks I guess I need to get to order parts. it came with new points and condenser but the they look like like the old one

Decided to make a video of what it doing. Seem like a lot of gas but the plug is dry. https://www.youtube.com/watch?v=6fqJ5LHbu1s

You understand don't you that it is blowing the gas OUT of the carb, not sucking in INTO the motor right??? More than likely the intake valve is stuck open. PULL THE HEAD!

Your intake valve is stuck open.

That what I told my uncle cause I had go kart do that one time I pulled the head use some pb blaster and tapped lightly on it.

I would advise against that, you need to remove the valve from the engine and clean all the gunk off it and put it back in. If you just free it up with pb it will just stick open again in no time, the burnt on oil and carbon is what causes it to stick so if you don't remove it all it will be a short lived repair.

Got it running seems to run pretty good still some work need to be done but the biggest problem is I was driving it around playing with the box blade and the steering broke it will turn to the right but not the left.

Fixed the Front loader.
Might have to skip forward had starting issues at first of the video https://www.youtube.com/watch?v=Eo83vubemu0