Newbe from Vernon, CT
 

Hi there just picked up a 102 did not run got it going and is running well
Looking for help in getting it set up with a mower needed advice ffom the pros
Ive bee in volved in the auto motive restoration trade over twenty years
And been involved in campaining a v8 mini rod at the state level since 90
Always liked cubs and have done some paint work in the past on them
Now i have my own to work on any help to locate a parts blow up are a compleye drop out assembly to fit the 102/ trade\bartor?

How do you set up the guick reply

In the window that you want to make a quick reply to, click on the icon at the very far right on the bottom. Looks like a paper with a quill or pen. And welcome to OCC.

Welcome to OCC! Glad to have you!

thanks
i
took a stab at that and think im going in the rite direction

Welcome to OCC!

thanks looking forward to playing around with the 102

cub102

Welcome to OCC from a former CT resident. Used to like to stop at Rein's deli when I was in Vernon.

thanks just a littlbit more up 30 and your there

i posted this question elseware here do you find the serial numbers on a
102 Ih Cub Cadet

adding get a set of new chrome caps wheel covers where to get and how much$
the have survived the crashes and bashes but have surface rust and need replating

I think it's on the rear axle tube on the back on the left. Should be a tag riveted on.

Welcome to the forum from a ct resident :-) :beer2:

Welcome cub102. If you look on the right side of the rear end there should be a little block that sticks off from the rear (in the middle of the block) it should be stamped there. Our 102 has it in that location and it was made in Dec of 65, hope that helps.

:Welcome2:

:Welcome2:

serial # location
 

Ok, here goes.
I took a look from bottom rear view left and right
Axel tubes and looking from the side rearward view from
front of fear wheels no riveted tabs no small machined block with stamped #

Just some casting #,s on both sides of tran/rear end
any other areas that may be shrouded by sheet metal

Welcome to OCC.

ok i looked and talked to a few other cub owners at the zagray show
they showed me on theirs,
the numbers are stamped right into the casting on the right side of the trans right next to the parting line for the reduction housing, no raised block and no pined tab/plate