New Cub Cadet 1210
 

I found this great site well researching for my new Cub Cadet 1210 and have really enjoyed reading thru the comments.
I have a question though...
My pto shuts off after about 30 minutes of mowing and then resumes normally after it cools down.
I have changed all the fluids,filter and greased everything properly.

Thanks for any suggestions.
Chris

I am sure someone will have a better suggestion, but your PTO bearing maybe getting hot and seizing up till it cools down and releases. I know some of the guys in here have had luck changing out the bearing. Much cheaper than finding another PTO.

:Welcome2:

Your profile pic looks great got any bigger images?

:WWP:

:Welcome2: Glad to have you!

pictures
 

took me a few tries but here are some pictures of my "new" 1210.
Chris

That is an awesome looking 1210... :beerchug:

Looks like it's brand new! That's in prefect condition! What a sweet score!

You have a really sharp 1210, Chris! :beerchug:

Welcome to the site. That's a great looking 1210. Where's is Perry at in OH? Congrats on your new cub!! :beerchug:

Ohio1210
 

Thanks everyone.
i looked at quite a few and bought this one without even hearing it run.I figured if it looked so clean it would run as well...few bugs here and there since it sat for awhile but very happy. My brother is really green with envy compared to his JD.
Perry is along the lake-about 40 miles east of Cleveland-I see a road trip to Patton Acres soon though.

I thought that was near Painesville up there. I used to pick up salt at mortan alot. Well If your gonna come down to see Rich at Patton acres then you have to stop by and see Mike and me. I live about 15 mins. north of Rich. I'll be headed down to see Rich this week sometime. I have a couple 82 series here with the 12hp in them, and their my favorite. If you need any help on them look me up.

What's that hood ornament? A bulldog?

welcome!
 

Welcome to the site, and I am glad to have you and my tractors "cousin" join us.:bouncy::Wave:

bulldog
 

Yea, I found an old Mack hood ornament and installed it. I removed the factory plastic trim piece and used one of the factory holes to mount the bulldog,then put a nut/bolt to fill the second factory hole.
Chris

Many thanks
 

As mentioned earlier-this is a great website.
i finished mowing today and was heading towards the garage the tractor stopped-no forward or reverse. i pushed it the last 100yds to the garage and started browsing the site within minutes.
3 hours later a new pin is installed on the engine side of the shaft and she's back...
Thanks again for all the post with all the right answers.
Chris

Chris it's great to have you here with us! I'm glad you got your 1210 fixed!:clap:

Same here!

:Welcome2: