I think that is awesome Allen!
I like to see when the fever spreads to others!:beerchug:

Same here, Mike! Since Jenn took the super, I can get more, right? :beerchug:

Allen

This is the trade ratio
6 Narrow Frames = 1 Super
5 Wide Frames = 1 Super

So your all good to go Buddy. :biggrin2:

Ok got side tracked watching The Game yesterday. I have one last engine bolt to remove. It's the one under the starter.:bash2: I'll get it tho.:beerchug: It had the engine replaced with series II. I guess some of the PO's replaced the engine at least twice.:bash2: The blown engine is going to Todd in GA.:beer2:

The wiring harness is dated Sept. 1979! I took a pic of it but the flash went off and you can't read it but I'll get one without flash today.:beerchug:

On to the pics.:beerchug:

Blown KT series II and the MAG18 that's going in it.
Attachment 30629 Attachment 30631

Sam I like your math LOL!

YES!
Get lots more Allen!:biggrin2:

Looks good Duke!
Get that thing done Slacker!:biggrin2:

ROFL

I still need to figure out what if any thing I need to do to wire this up.:bigthink:

Duke

You have been on OCC almost all day. I know because about the only thing I did today was watch the Formula 1 race and check what was going on here on OCC and you have been on as much as I have. Turn the computer off and get your lazy butt to work. It won’t fix itself. I'm sure Roland can send you a wiring diagram. Or you can haul it up to Galax and in a couple hours it will be running. If I wasn’t waiting for parts I would have the rear finished for the 2182. :biggrin2:

I like your thinking, guys!