You guys are all wrong! It is plane too sea that its got to be the kanooder valve. you dont need no whole sawz just a hack sawz. you start buy kutting across the frame in front of the seet. cut all the down and everthing inside. then bend the tractter like a bendy straw so yoos can get to the kanooder valve .then replace the startr switch

I don't know how to upload pictures..... all this stuff is so hard. :BlahBlah:


The steering wheel? Or the rear wheel? I'm so confused......


I didn't even think about the John Deere forum. I was getting ready to make a post of Facebook. I hear the Cub Cadet pages on there are just full of really smart people who are extremely helpful!


That is such an awesome idea! That seems way easier.... bending it in half like that. I do have two hacksaws. Maybe I can duct tape them together to get done twice as fast!!!



Seriously guys..... I really was mowing and the tractor just stopped. That really happened....

I recommend you scrap the 1811 and go buy Lew's new to him Simplicity!:beerchug:

Check the roll pin :beerchug:

Roll pin?

Attachment 88265

Did I really say this? :ExtremeFunny:

:bash: Well from what I see and hear you better get on Facebook and ask the "profeshionals"

Attachment 88266

Jon, just wait till the morning and Sam will be on. He'll know what to do.
Just curious, you didn't eat before you went mowing? Did you? You waited at least an hour? OR was that something else all together?:bigthink:

I really hope either can help. :NailBite::NailBite:

Well...


I'll spill it. The tractor really did stop moving while I was mowing. I wasn't too phased. BTDT. Drug it up to the shop to see which pin broke. It was the one on the motor. Went to the "stash" to get a new one..... and I was out of them. Dang it. Took them with me my last trip to my bro's and installed them on his 126 when we put the creeper in. I forgot to order more. Oh well. I have enough parts laying around, I just grabbed a used driveshaft off the shelf and knocked out the pin and put it in the 1811. Took longer to go get my pin punches that were in my toolbox 2 miles away. I did sit down and order a new box of pins though. McMaster Carr. $12 + shipping for a box of 50 of them. I like to keep them on the shelf. Way better deal than buying from CCC. They want nearly $3 per pin!! :bigeyes: I did order the regular ones. Not sure if I should have got the harder ones. Sheer strength on the regular ones is like 5500# as opposed to 7700# or something like that on the harder ones. They were $12 for a box of 25, so double the cost. No reason not to keep things that fail on the shelf boys. I should have ordered some tie rod ends too. I think I used the last I had this spring. :bigthink: