Only Cub Cadets - Breather position on 1450 rear end cover?

Page 2 of 2

Show 40 post(s) from this thread on one page

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)

- - Breather position on 1450 rear end cover? (https://www.onlycubcadets.net/forum/showthread.php?t=12274)

terkaa

07-22-2011 11:55 PM

Quote:

Originally Posted by westofb (Post 83843)

If that is a PO modification, it was done very well....it looks to be factory installed. What does the bung the breather is installed in look like from the bottom side? Thanks for the pics!

Well it looks as good as other side. There was no welding seam it looked like it was just pressed HARD to a bit tight hole so it had "welded" itself together.

Tero

terkaa

07-23-2011 12:12 PM

Well if I rotate this plate to its original position then hydro input gear throws oil directly to breather(and it bubbles out). But when it is rotated like this breather is on top of ring gear(and it does not bubble). Hmmm.. Do I have one of the very latest QL's or why is breather installed differently? I'll post serial no later. And yes of course I have checked Hytran fluid level as I replaced rear cover gasket and also oils right after replacing hydro gasket. And yes level is correct.

Tero

terkaa

07-23-2011 12:47 PM

Serial No is 2050660U644916 I have posted pics of it to lets see your IH cubs chain.

Tero

terkaa

07-23-2011 07:11 PM

Yes this might be it. If you look at first pic you can see that there is also "almost drilled" spot on center of top cover. Also dealer might of noticed this and it was their repair for it. January 1979....:bigthink: Hmmm I am from March 1979 so this thing is only couple months older than I am :beerchug:

All times are GMT -4. The time now is 09:18 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page