PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
782 steering wheel removal?
How the %$&(&^$# does it come off? Bought a roller that must have been setting outside & the steering wheel splines are risted to the shaft. How do I get it off? I have used a 3 jaw puller but just screws up the plastic of the steering wheel.
Any suggestions? |
#2
|
|||
|
|||
i will be having to do the same here shortly...plenty of play in it now...
|
#3
|
||||
|
||||
Start by soaking it with PB blaster or AeroKroil everyday for about a week!
They can be stubborn! |
#4
|
||||
|
||||
Seek & ye shall find!
This has been covered before & do a search & find out. Guys on this site are good by making gizmos that make the job easier. I'd give ya the link but i'm not that good. It will be worth your while. Nik,
__________________
It dont cut grass, but its yellow. |
#5
|
||||
|
||||
I tried soaking for a week and all methods I could think of. None worked.
Then I got this: http://www.harborfreight.com/14-piec...set-30305.html Popped it right off in 5 seconds.
__________________
Original, 109, a pair of 122s, 124 with power lift, 124 with creeper, 126, 147, 1050, 1200, two 1250s, 1450 Dual Stick , another 1450, two 1650s, Gannon Earthcavator, Haban sickle bar and a bunch of other things you either pull, push or hang underneath. |
#6
|
||||
|
||||
Quote:
|
#7
|
||||
|
||||
The wheels I had trouble with all had their caps on.
__________________
Original, 109, a pair of 122s, 124 with power lift, 124 with creeper, 126, 147, 1050, 1200, two 1250s, 1450 Dual Stick , another 1450, two 1650s, Gannon Earthcavator, Haban sickle bar and a bunch of other things you either pull, push or hang underneath. |
#8
|
|||
|
|||
I took a 2"x4" block and used an appropropriately sized hole saw to cut a hole that would contact the plastic steering wheel base, but clear any obstructions, then i cut the block in half (half of the hole on each side) I did the same thing with a piece of plate steel, take all 4 pieces and a puller ( i used 2 jaws) put the cut steel plate around the column. put the cut wood block on top of the plate steel (so the seam is at a 90 degree angle to the plate. raise the whole pile up to the base of the steering wheel and while using your second and third hand hook the puller around the steel plate and snug it.
Then I put a ratchet on it and cranked on it there was a horrible pop, and the wheel was free, the column was undamaged, and I was thrilled |
#9
|
||||
|
||||
Here is a pic of what i think he is talking about MattG posted awhile back
__________________
Brian April 1979 1200 Quietline 44A deck 1988 1211 customized into a 1288 with a K301AQS 38C deck and a 1864 54” deck . Snow blades 42" and 54" . Brinly disk, brinly plow a cultivator and a $5 brinly yard rake! |
#10
|
|||
|
|||
pretty close, a much nicer looking version of what I had pieced together very quickly
|
Thread Tools | |
Display Modes | |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.