Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Folks we have a new owner!
Greg Rozar AKA- CubDieselFan


Go Back   Only Cub Cadets > Cub Cadets > CCC/MTD Cub Cadet built Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 04-06-2018, 07:30 PM
clay1811/44c's Avatar
clay1811/44c clay1811/44c is offline
Senior Member
 
Join Date: May 2012
Location: Illinois
Posts: 498
Default 2284 But honey it was to nice to pass up.

I've been watching for donor motor for my 1872 and found this. This was way to nice for a donor, so I have other plans. I'm not going to sell it, but what do you think it is worth? It is 858hrs and all solid plastic. No issues that I can find thus far.
Attached Images
File Type: jpg 20180406_185506.jpg (45.7 KB, 253 views)
Reply With Quote
  #2  
Old 04-06-2018, 11:07 PM
john hall's Avatar
john hall john hall is offline
Grand Member
 
Join Date: Jul 2009
Location: Durham, NC
Posts: 3,095
Default

That thing is BORING. Anything that looks that nice probably only needs an oil change and blades sharpened. I bet your dash lights even work!

So did it come with the Sam Mac approved hold hold down device?
__________________
2072 w/60" Haban
982 with 3 pt and 60" Haban
1811 with ags and 50C
124 w/hydraulic lift
782 w/mounted sprayer
2284 w/54" mowing deck
Reply With Quote
  #3  
Old 04-06-2018, 11:33 PM
clay1811/44c's Avatar
clay1811/44c clay1811/44c is offline
Senior Member
 
Join Date: May 2012
Location: Illinois
Posts: 498
Default

Quote:
Originally Posted by john hall View Post
That thing is BORING. Anything that looks that nice probably only needs an oil change and blades sharpened. I bet your dash lights even work!

So did it come with the Sam Mac approved hold hold down device?
He did change the oil. He claims he changed oil every 50 hours and clean as it was I believe him. Blades do need sharpening. All lights do work. I should have taken the Sam Mac hold down off for the photo. I installed the hold down for the long trip home. I've seen to many hoods along the highways. Even though I never went over 40mph. Mapguest 3.7 miles, 9 minutes. This trip makes up for the St.Louis to K.C. run.
Reply With Quote
  #4  
Old 04-07-2018, 12:27 AM
jaynjeep's Avatar
jaynjeep jaynjeep is offline
Grand Member
 
Join Date: Nov 2012
Location: Statesboro, GA
Posts: 2,143
Default

Quote:
Originally Posted by clay1811/44c View Post
I've been watching for donor motor for my 1872 and found this. This was way to nice for a donor, so I have other plans. I'm not going to sell it, but what do you think it is worth? It is 858hrs and all solid plastic. No issues that I can find thus far.
Wow that is a nice tractor! 2284's have got to be pretty rare.. I've never seen one in these parts at all!

Congrats on the great score!
__________________
Jay

40 years of Using and playing with IH Cub Cadets!

Proud owner of the following:
Cub Farmall, Super A Farmall, Original, (2)70's, 72, 100, 102, 123, 105, 125, 127, 108, 128, 1450, (3)782's, Yellow 982, 1782, "Sam's" 2182, M Farmall and a #7 trailer
Reply With Quote
  #5  
Old 04-07-2018, 07:00 AM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
 
Join Date: Feb 2010
Location: Galax VA
Posts: 18,753
Default

That is sweet! Should be worth a couple grand anyway.
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #6  
Old 04-07-2018, 08:35 AM
IHCubCadet147's Avatar
IHCubCadet147 IHCubCadet147 is offline
Grand Member
 
Join Date: Feb 2018
Location: PA
Posts: 1,732
Default

Nice tractor!
__________________
125, 126, 147, 129, 149 x 2, 1450, 882, 1810, 1320, 1440, 2135, 2 129’s for parts/project, 1950 Farmall Cub
38" LT mower deck, 4 42" triangle mower decks, 2 44A mower decks, 2 50C mower decks, 42” GT deck, 3 42" snow/dirt blades, 42" landscape rake, #4 cart
Reply With Quote
  #7  
Old 04-08-2018, 07:23 AM
Dirty Steve's Avatar
Dirty Steve Dirty Steve is offline
Grand Member
 
Join Date: May 2011
Location: NY
Posts: 1,821
Default

Congrats on the 2284
__________________
http://www.onlycubcadets.net/forum/s...ad.php?t=42646

70, #1 cart. Brinly Cultivator. Some wheel weights.

{125, 126, 2072-Sold~regrettably, 2284 60 inch Haban 325 deck., 451 snowblower, 2182-60 inch Haban 374 deck- "Money Pit", 401 Haban 54 inch dozer blade- rebuilt, 1440-down the road, Another 2182 for parts. Another 2284 for parts. 450 blower. 1812-sold, 2072 w/ Haban 374, and a 2182#3 w/ Haban 325}-------> All SOLD
Reply With Quote
  #8  
Old 04-08-2018, 10:03 AM
DoubleO7's Avatar
DoubleO7 DoubleO7 is offline
Grand Member
 
Join Date: Nov 2013
Location: Crystal River, FL
Posts: 1,476
Default

looks real nice.......except for those scratches in the hood from the bungee hooks, LOL.
Reply With Quote
  #9  
Old 04-10-2018, 08:42 PM
clay1811/44c's Avatar
clay1811/44c clay1811/44c is offline
Senior Member
 
Join Date: May 2012
Location: Illinois
Posts: 498
Default

It appears I have electrical issues. It started and loaded on the trailer just fine. Got home started and unloaded off the trailer ok. Then it stuttered in the yard and quit at the garage door. Thought maybe out of fuel, added a couple of gallons. It starts and dies when you let go of the key. Saw electrical tape on the connector on ignition switch. Pulled that off and the black wire terminal was toast. Pulled that apart and replaced terminal and block. Still same thing start and quit. I'm leaning towards a bad ignition switch. Do the headlights stay on all the time? The switch seems to have a start, run with lights and off positions only, is this correct? My 1811 has start, run, run with lights and off positions. I do see the parts book calls out 2 different switches for the 1811 and 2284. When I turn the key on only I do hear and feel the fuel solenoid click. But if I touch the key just a little the solenoid clicks in and out and lights stay on. Any thoughts guys?
Reply With Quote
  #10  
Old 04-10-2018, 10:27 PM
john hall's Avatar
john hall john hall is offline
Grand Member
 
Join Date: Jul 2009
Location: Durham, NC
Posts: 3,095
Default

Take a look here about some of the issues I found with mine. There are some links to various pages here on OCC that have some info you should read. I don't remember if I fixed my switch or replaced the whole thing--think I changed the whole thing. Seems I have REALLY bad luck buying Cadets with bad key switches.
http://www.onlycubcadets.net/forum/s...t=47313&page=3
__________________
2072 w/60" Haban
982 with 3 pt and 60" Haban
1811 with ags and 50C
124 w/hydraulic lift
782 w/mounted sprayer
2284 w/54" mowing deck
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:00 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.