Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Folks we have a new owner!
Greg Rozar AKA- CubDieselFan


Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #81  
Old 12-31-2017, 07:04 PM
V30crewcab V30crewcab is offline
Senior Member
 
Join Date: Aug 2013
Location: Tennessee
Posts: 537
Default

could also have a crappy connection somewhere that gave out. might want to clean all the connections, including grounds.
__________________
1782, 1862, 1440(sold), 89 1050, 128, 70, some run some don't!
72 scout
IH 404 tractor
Reply With Quote
  #82  
Old 12-31-2017, 09:27 PM
sawdustdad's Avatar
sawdustdad sawdustdad is offline
Grand Member
 
Join Date: Dec 2012
Location: USA
Posts: 2,627
Default

Starting a hydro in cold weather really challenges the battery, and all your electrical connections, grounds, etc. I sometimes turn the key to run, and apply jumper cables directly to the starter (ground and Positive terminals) to maximize voltage (and, hence, current) to the starter.

It's only supposed to get down to 14 here tonight. Supposed to be 7 degrees F Tuesday morning, though. That's about as cold as it ever gets there on the Chesapeake Bay (Rappahannock River area). Thank goodness!

If you remember the story about the explorer/settler John Smith (of the Jamestown 1607 settlement), when he was stung by a stingray (at what is now Stingray Point) and treated by Native Americans on what is now called Antipoison Creek. That is just a couple miles from where we live.
__________________
Reply With Quote
  #83  
Old 01-01-2018, 01:49 PM
Marko141's Avatar
Marko141 Marko141 is offline
Senior Member
 
Join Date: Dec 2017
Location: New York
Posts: 244
Default

Went looking for a magnetic heater and every store was sold out, go figure. Anyways I got home and it got up to a warm 14 degrees and the sun was out. Decided to try to start my 127 and to my amazement the slight change in temp was all it needed. I pull the choke and it started right up! Decided to blow some snow in the yard just because I could.
Attached Images
File Type: jpg IMG_2142.jpg (24.1 KB, 85 views)
__________________
Cub Cadet 127, 1450, read bottom plow, blower, tiller, wheel weights, chains
Reply With Quote
  #84  
Old 01-01-2018, 01:51 PM
Marko141's Avatar
Marko141 Marko141 is offline
Senior Member
 
Join Date: Dec 2017
Location: New York
Posts: 244
Default

I still can't figure out the photos, some are fine and others are turned, no matter how I hold my phone.
__________________
Cub Cadet 127, 1450, read bottom plow, blower, tiller, wheel weights, chains
Reply With Quote
  #85  
Old 01-01-2018, 01:54 PM
Marko141's Avatar
Marko141 Marko141 is offline
Senior Member
 
Join Date: Dec 2017
Location: New York
Posts: 244
Default

Let's try again
Attached Images
File Type: jpg IMG_2142.jpg (24.5 KB, 85 views)
__________________
Cub Cadet 127, 1450, read bottom plow, blower, tiller, wheel weights, chains
Reply With Quote
  #86  
Old 01-11-2018, 12:08 PM
Marko141's Avatar
Marko141 Marko141 is offline
Senior Member
 
Join Date: Dec 2017
Location: New York
Posts: 244
Default

Finally got around to taking some more photos, was almost -30 last week and over 50 today so it was great to get outside. I started everything up without issues and drove them around. Few photos, a little of everything, I also seem to have an extra metal batter/dash that has just some minor surface rust, couldn't tell you where it came from it came with the tractor package deal. Pointed out a piece on the blower, not sure of its purpose, and does the muffler setup seem right? Thought it would bolt but I couldn't tell you, first tractor only had it a month now.
Attached Images
File Type: jpg IMG_2159.jpg (33.2 KB, 61 views)
File Type: jpg IMG_2160.jpg (26.1 KB, 60 views)
File Type: jpg IMG_2161.jpg (27.9 KB, 61 views)
File Type: jpg IMG_2162.jpg (35.3 KB, 61 views)
File Type: jpg IMG_2163.jpg (22.9 KB, 61 views)
File Type: jpg IMG_2164.jpg (31.3 KB, 61 views)
File Type: jpg IMG_2165.jpg (24.5 KB, 60 views)
File Type: jpg IMG_2166.jpg (27.2 KB, 60 views)
File Type: jpg IMG_2167.jpg (28.5 KB, 60 views)
File Type: jpg IMG_2168.jpg (32.0 KB, 60 views)
File Type: jpg IMG_2169.jpg (32.2 KB, 60 views)
File Type: jpg IMG_2170.jpg (31.5 KB, 61 views)
File Type: jpg IMG_2171.jpg (30.1 KB, 60 views)
File Type: jpg IMG_2173.jpg (15.7 KB, 60 views)
File Type: jpg IMG_2174.jpg (19.8 KB, 60 views)
File Type: jpg IMG_2175.jpg (22.4 KB, 61 views)
File Type: jpg IMG_2176.jpg (31.5 KB, 60 views)
File Type: jpg IMG_2180.jpg (28.1 KB, 60 views)
File Type: jpg IMG_2181.jpg (34.9 KB, 61 views)
__________________
Cub Cadet 127, 1450, read bottom plow, blower, tiller, wheel weights, chains
Reply With Quote
  #87  
Old 01-11-2018, 12:11 PM
Marko141's Avatar
Marko141 Marko141 is offline
Senior Member
 
Join Date: Dec 2017
Location: New York
Posts: 244
Default

Might also need a new carb, some gas spitting out from under that throttle hook up, you can see where dirt and grime is starting to build up, best price for a new carb if I end up needing one?
__________________
Cub Cadet 127, 1450, read bottom plow, blower, tiller, wheel weights, chains
Reply With Quote
  #88  
Old 01-11-2018, 01:53 PM
J-Mech J-Mech is offline
Banned
 
Join Date: Apr 2013
Location: Oblong, Illinois
Posts: 17,594
Default

Carb looKS fine. That dirt is normal accumulation. Even if it needs work, rebuild it. No reason to buy new unless that one can't be fixed.

Muffler looks fine to me.

I'd replace that junk fuel line though. Does it still have a sediment bowl on it? Or did some PO remove it and install a filter? If it doesn't have a sediment bowl, put one on it. Toss the fuel filter in the trash.
Reply With Quote
  #89  
Old 01-11-2018, 02:00 PM
Stephen.Mellish's Avatar
Stephen.Mellish Stephen.Mellish is offline
Member
 
Join Date: Aug 2016
Location: PE, Canada
Posts: 64
Default

That part on the blower you are pointing to is to stabilize the mount when it is removed from the tractor. It locks it all together so that it does not move/flex when it is sitting on the ground, removed from the tractor.

IMG_2176_highlighted.jpg

There should be an extra hole near the end of the upper mount bar that you secure to that stud and wing nut on the lower mount.
You unscrew the wingnut (circled in red). You take the upper mount arm and remove the end from the tractor side (orange arrow pointing), swing it down to the stud the wing nut was on and then screw the wingnut back on.
__________________
The Collection, so far: Cub Cadet 100(x2), 125(x2), 123(x2), 70, 71. Adding more when I can find them.
Reply With Quote
  #90  
Old 01-11-2018, 04:37 PM
Marko141's Avatar
Marko141 Marko141 is offline
Senior Member
 
Join Date: Dec 2017
Location: New York
Posts: 244
Default

The sediment bowl is still on it, no inline filter thankfully, and I'll keep the carb as is for now, it's running good so I'll leave it be.

Thanks for the reply on the blower, I wasn't sure what the purpose of it was, just there doing nothing.
__________________
Cub Cadet 127, 1450, read bottom plow, blower, tiller, wheel weights, chains
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:12 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.