Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Speciaalties R. F. Houtz and Sons

Patton Acres IH Cub Cadet Parts

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Folks we have a new owner!
Greg Rozar AKA- CubDieselFan


Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 05-30-2011, 04:24 PM
jpianalto jpianalto is offline
Senior Member
 
Join Date: Apr 2011
Location: Arkansas
Posts: 155
Default in over my head a bit... wiring...

i bought a wiring harness for my 147 because i taped up some wires that were bare leading to the voltage regulator... they were so bad i don't understand how any current was flowing through them...

i started exploring with the thought of replacing the harness... i have a diagram btw...

on the 147 where the fame is bowed out some, the engine seems to be pinning the wiring harness to the frame... am i going to have to loosen the motor to replace the wiring harness?!? surely not!

what's the trick here?

and whoever wired this thing used all the same color wire! ugh!
the starter is a 4 prong and the connector that came on the harness is 3 pronged...

i hope i didn't just open up a huge can of snakes here...

jp
__________________
147 w/ 42" deck w/ 3pt hitch all in memory of my grandpa's 124
Reply With Quote
  #2  
Old 05-30-2011, 06:34 PM
R Bedell R Bedell is offline
Administrator
 
Join Date: Mar 2007
Location: Michigan
Posts: 13,693
Default

Route the harness in the area of the "bow out" underneath the bow.

Sounds like you need to get the correct Ignition Switch.....OR....chop the 3 prong plug off, install some new female crimp connectors, and wire up to the existing switch. Your call.
__________________
Roland Bedell

CC Models: 100, 105, 1450, 782, (2) 784, & 2072

Buy: Made in the USA
Reply With Quote
  #3  
Old 05-30-2011, 07:20 PM
jpianalto jpianalto is offline
Senior Member
 
Join Date: Apr 2011
Location: Arkansas
Posts: 155
Default

i'm not sure that the wire will fit under that bow... it's tight... the wire that's there barely moves with very snug tugging... each end has a much bigger section to fit through there
__________________
147 w/ 42" deck w/ 3pt hitch all in memory of my grandpa's 124
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:11 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.