Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Folks we have a new owner!
Greg Rozar AKA- CubDieselFan


Go Back   Only Cub Cadets > Cub Cadets > CCC/MTD Cub Cadet built Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 11-09-2017, 05:10 PM
jon81SC jon81SC is offline
Member
 
Join Date: Mar 2016
Location: PA
Posts: 44
Default NOW what needs to be replaced?

As much as I really like this 1210 (when it's running), it's failure to hold a charge is becoming frustrating. I've replaced the battery, the voltage regulator, and most recently the coil (done by the local CC dealer). They went over the tractor looking for additional things to fix, and found nothing. I asked about the stator and they told me it was fine. This was 5 weeks ago. It started & ran flawlessly, cuts beautifully...until today. Any suggestions? Thank you in advance!
Reply With Quote
  #2  
Old 11-09-2017, 05:59 PM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
 
Join Date: Feb 2010
Location: Galax VA
Posts: 18,755
Default

Get a battery disconnect switch, put it between the + and the battery cable then get a trickle charger to keep the battery charged and you should be good. No this doesn't cure whatever is wrong but your battery will be charged. Other than that the only other suggestion I have is that you sell the 1210 and go buy a new tractor. The 1210 is 30+ years old so it is at the age that it is going to need some TLC.
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #3  
Old 11-09-2017, 06:43 PM
J-Mech J-Mech is offline
Banned
 
Join Date: Apr 2013
Location: Oblong, Illinois
Posts: 17,594
Default

I'd be checking the ignition switch....

Only way to find a battery draw is to disconnect the negative battery cable, then connect a test light to the cable, and the other end to the battery post. Key off, if it lights up, you have a draw. If it lights, start disconnecting things one at a time until the light goes out. Isolate that circuit and repair the bad part/wire. If it doesn't light up, you either have a bad battery, or a charging problem.

Or do as Sam suggested.

Dealer likely doesn't have any mechanics smart enough to fix an electrical issue. Especially if they replaced the ignition coil to fix a draw. Not related in the least.
Reply With Quote
  #4  
Old 11-09-2017, 06:45 PM
DeltaCub's Avatar
DeltaCub DeltaCub is offline
Grand Member
 
Join Date: Jul 2014
Location: Ohio
Posts: 1,509
Default

X 2 Jonathan....you beat me to the reply!
__________________


Queen Of The Quietlines!
Reply With Quote
  #5  
Old 11-09-2017, 06:49 PM
darkminion_17's Avatar
darkminion_17 darkminion_17 is offline
Grand Member
 
Join Date: Aug 2010
Location: New Jersey
Posts: 11,002
Default

Lots of good info to start with but, some repair shops, dealers have a supply of mice that they put in your blower housing to cause issues with your tractor, you can weed these guys out by asking if they like cheese.
__________________
Up to 530 and counting...
I give up updating my profile!
Reply With Quote
  #6  
Old 11-09-2017, 07:55 PM
J-Mech J-Mech is offline
Banned
 
Join Date: Apr 2013
Location: Oblong, Illinois
Posts: 17,594
Default

Quote:
Originally Posted by darkminion_17 View Post
Lots of good info to start with but, some repair shops, dealers have a supply of mice that they put in your blower housing to cause issues with your tractor, you can weed these guys out by asking if they like cheese.
Reply With Quote
  #7  
Old 11-10-2017, 07:33 AM
Vrobert's Avatar
Vrobert Vrobert is offline
Senior Member
 
Join Date: Sep 2017
Location: MD
Posts: 274
Default

Do you have a volt meter? Make sure the voltage on the battery is between 13.5 and 15 volts when running.

And make sure the battery is clean. Residue on a battery can make it slowly drain.

Please report back what you find.
Reply With Quote
  #8  
Old 11-10-2017, 09:14 AM
J-Mech J-Mech is offline
Banned
 
Join Date: Apr 2013
Location: Oblong, Illinois
Posts: 17,594
Default

Quote:
Originally Posted by Vrobert View Post
Do you have a volt meter? Make sure the voltage on the battery is between 13.5 and 15 volts when running.

And make sure the battery is clean. Residue on a battery can make it slowly drain.

Please report back what you find.

15V is a tad high. If he is getting 15V, then he probably does have residue on the battery, due to it getting overcharged. 14.5/14.6 is as high as you should see on a 12V charging system.
Reply With Quote
  #9  
Old 11-10-2017, 04:58 PM
jon81SC jon81SC is offline
Member
 
Join Date: Mar 2016
Location: PA
Posts: 44
Default

Guys,

Thank you all. Will try the test light,

Darkminion, I DID notice a large wheel of cheddar on the shelf when they brought me back into the service area.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:26 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.