PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
another
well, my buddy (lill cub) was mowing with my 102 today and he heard something ratteling. He stopped to see if it was the hood or gas tank, but as he did that he heard it let go. another connecting rod broke. that is the third k241 i have in my garage now with a broke connecting rod. is their any thing to do to prevent this? well i guess i will be heading to cubcrazys to bring her back to life. RIP K241. MOMENT OF SILENCE PLEASE!!!
__________________
Have you driven a cub lately |
#2
|
||||
|
||||
Sorry to hear that Darren.
|
#3
|
|||
|
|||
I have had a few Kohler connecting rods let go. I have read and now believe, that the Aluminum Rod gets fatigued over years. Now, anytime I open up a Kohler, it gets a new connecting rod regardless if it looks and checks out good. Cheap insurance as compared to tearing one down again.
__________________
Roland Bedell CC Models: 100, 105, 1450, 782, (2) 784, & 2072 Buy: Made in the USA |
#4
|
||||
|
||||
That rattling was probably from one of the rod bolts backing out causing a lot of play in the connecting rod. That's what happened to the motor in a tractor I got for parts. But since these blocks are cast iron sometimes you get lucky and nothing else breaks. You see cast aluminum motors put the rod right through the side of the block all the time.
|
#5
|
||||
|
||||
shouldwe,
Not good when a engine goes south! I have worn them out but not had one come apart YET! Good luck with the repairs. That 102 is a mate to the one I have. Yours looks a little better than mine. Regards, Chris
__________________
Casbohm Maple and Honey www.mapleandhoney.com Cubs: 147R and the "train", 127 elec lift, 127, 125, 106, 102, 100, 86, 73, Brinly plow, Snow thrower, 2 Rototillers, several mower decks and several snow plows, #1 cart, Grandkids barrel cart. |
#6
|
||||
|
||||
well, i got it the motor out today, the rod broke about an inch and a half up from the crank. the crank looks like it will be ok might have to take it down ten, but we will see. it looks like it is going to need a master kit. i would like to get another motor so someday when i get around to rebuilding this one i will have one on the shelf. it is all in fun with these old beast.
__________________
Have you driven a cub lately |
#7
|
||||
|
||||
David Kirk, (a Kohler engine genius) says you can fit a 18 hp con rod in the 10,12,14,16 horse Kohler engines. The 18 hp con rod is forged instead of diecast and it is made of Alcoa aluminum, and is supposed to be very good insurance against rod failure.
He talks about it here-http://www.kirkengines.com/Hyperlink%20Files/KILLER%20KOHLER%20Part%20I.doc For more of his interesting pdfs scroll to the bottom of his site- http://www.kirkengines.com/ |
#8
|
||||
|
||||
[QUOTE=ljones;74897]David Kirk, (a Kohler engine genius) says you can fit a 18 hp con rod in the 10,12,14,16 horse Kohler engines. The 18 hp con rod is forged instead of diecast and it is made of Alcoa aluminum, and is supposed to be very good insurance against rod failure.
Do not forget to balance the rotating assembly if you change to a different rod.
__________________
Nemesis |
#9
|
||||
|
||||
Quote:
__________________
if you want a real tractor, you need a CUB CADET!! |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.