View Single Post
  #22  
Old 10-14-2017, 11:57 PM
Vrobert's Avatar
Vrobert Vrobert is offline
Senior Member
 
Join Date: Sep 2017
Location: MD
Posts: 274
Default

Quote:
Originally Posted by zippy1 View Post
Could be a seal or cover or valves. Trunnion looks okay from the picture.
How does the back of the engine look now that you got the side tins off? By the flywheel, any old oil, dirt in and around there?
Flywheel looked clean, no nests or gunk on the fins. There was a little bit of crud on the alternator stator but it cleaned up nice. After the carb is rebuilt I'll look for leaks around the pump.

Any tips for the carb rebuild? I'll make note of the current adjustments before rebuild. I'll clean out all passages, replace needle and seat, then warm it up and adjust the idle mixture.

Here is the improved schematic. I'm not sure how to attach a large enough file that it can be viewed.
Reply With Quote