View Single Post
  #2  
Old 12-02-2012, 06:40 PM
darkminion_17's Avatar
darkminion_17 darkminion_17 is offline
Grand Member
 
Join Date: Aug 2010
Location: New Jersey
Posts: 10,984
Default

I just did this replacement the other day.
Disconnect the battery.
Then you lock down the clutch pedal.
Remove clutch cover.
Remove the hood.
Then you remove the two roll pins on the drive shaft where the two clutch plates are.
Remove the choke,throttle cable,coil wire,and if you have the mower deck on it ,the belt.
Remove the pto turnbuckle.
Remove the 4 bolts holding the motor.
Slide motor forward and remove the front plate,disc, rear plate and teaser spring.If you still don't have enough room you will have to remove the front grill casting .

That was easy... but if you go this far why not just remove the clutch entirely,you may need to get a new shaft,and go over everything,true up the plates,new t.o. bearing and clutch spring.You may need a new yoke and clutch arm with pin.

Hope this
h
e
l
p
s
__________________
Up to 530 and counting...
I give up updating my profile!
Reply With Quote