View Single Post
  #1  
Old 04-23-2011, 07:17 PM
_DX3_'s Avatar
_DX3_ _DX3_ is offline
Grand Member
 
Join Date: Jun 2010
Location: Richmond, Kentucky
Posts: 5,798
Default Throttle Shaft Bushing Part Number for those that might need it.

I decided to remove the throttle shaft on my 128's carb and get it tightened up. I went to Ace Hardware who carries Hillman products and talked with the Hillman representative that works at that store. He told me they had the bushings but that they now carried them in Servalite brand name. Hillman bought out Servalite.

The bushing fits perfectly and you do not have to drill your carb body. It removed all looseness in the throttle shaft. Also adding that the butterfly screw size is: 3-48 x 7/32"
A 3-48 x 1/4" works fine.

The Servalite part number is: ST814-2

They were about .80/each
Size is 7/16"x1/4"x1/16"

Here is the bushing:


The first bushing in place to be seated:


I used two bushings and a 6mm socket to seat them. Very very easy to do.:


Hope this is of some help.
__________________
DWayne

1973: 128, ag tires, 3pt. lift, spring assist, lights, 42" Deck

10" moldboard plow

2016 XT1 42" deck 18HP