View Single Post
  #16  
Old 09-14-2017, 12:56 PM
charlie105's Avatar
charlie105 charlie105 is offline
Senior Member
 
Join Date: Feb 2011
Location: Woolwich, Maine
Posts: 225
Default Drive hub

Yes I have roll pin punches, but standing it on end still wouldn't give me any way to back up the shaft and protect the shaft bearings if I use a hammer & punch to drive the pin. I need a press or clamp to drive the pin without impacting the hydro shaft bearings.Trying to figure out how to modify a C clamp to do the job.
Reply With Quote