View Single Post
  #23  
Old 05-28-2017, 03:13 PM
Merk Merk is offline
Grand Member
 
Join Date: Mar 2009
Location: Ohio
Posts: 2,180
Default

Materials used to build my clutch fixture:

The material used is 1/2 X 2 inch.
The angle iron is 1 1/4 inch.
The threaded rod is 1/2 thread.
The length of the threaded rod is 18 inches.
Overall length of the frame is 22 inches.
Height is 8 inches.

The bushing that goes between the threaded rod is 4 1/2 inches long and 1 inch outside diameter. The end towards the threaded rod is 1/2 inch diameter. The ends towards the clutch assembly/driveshaft is 5/8 inch diameter. Part was made on a lathe.

Threaded rod end:
There was a 1/2 nut welded to a flat piece of steel. This nut/plate was welded to the uprights. Centerline height is 7 inches.

End that holds driveshaft in place:
Shim stock was used to get the 5/8 spacing for the drive shaft. Support piece is 6 3/4 inches.

Clutch holding fixture was built by my Son in his high school ag shop.
__________________
Project Uncle Dick
Cub Cadet 70
http://www.onlycubcadets.net/forum/s...ght=Uncle+Dick