View Single Post
  #8  
Old 05-04-2016, 11:11 PM
jim nicholson jim nicholson is offline
Senior Member
 
Join Date: Aug 2010
Location: Lisbon, Ohio
Posts: 101
Default

Sam Mac, I agree with you and have considered drilling out the jet. I have a set of drills to drill out torch tips which are great for that.I'll just gauge it with a drill and use the next one bigger and see what happens. Worst case scenario, a new jet is only $11.
Here's to experimentation..... and maybe some knowledge.
By the way there are no fuel screws, just an idle speed screw.
I hate to run it with a lean fuel condition as this makes it run hotter.
Reply With Quote