The blades themselves are all the same, but you’ll need a different subframe for narrow vs wide frame. It’s a bit of a pain to do, but a properly sized 2x4 and a hammer will get the blaze separated from the subframe. You’ll also need a different lift rod. They aren’t hard to fabricate, but it does take some work.
A 1050 is a wide frame.
If you have a hydraulic angle blade that has functional hydraulics and you don’t intend to use it, you should sell it to someone. Those are fairly well sought after. I’m sure someone would make you a good deal. Blades with subframes around here go from 50-100 bucks. Hydraulic angle ones I’ve seen go from 150-200 depending on size and condition.
|