Quote:
Originally Posted by RLause
Gorilla duct tape on the seat. Clean it good first with alcohol and the tape will stick better.
|
Now I really know I'm among friends here!
I pulled the front tins off and no critters to be seen. I'm a little worried about the side tins that bolt to the head. The first bolt I tried is seized I think. I may just pressure wash around them and spray some penetrating fluid in case they have to come off later.
I ordered a fuel pump and a carb kit. Once it's running smooth I'll put the seat on it and try to get it to move under it's own power. The hydro fluid is so clean I don't plan to change it. I think both fluids were changed when the PO parked it.
The trans has very little resistance so I have been rolling it around by hand. Is that going to damage the hydrostat? Do I need dollies to move it around?
I found the wiring schematic difficult to understand at first. Some of the switches aren't labelled and the details are vague. I'll modify the schematic and post it here.
Rob