[vr4Legacy]

I'm going to pull the trigger on the PTO rebuild. I have a week off work next week and I'm going to try and button up the 149.

Here is what I have on the list
From CubCadet.com
1 - 759-3489 - P.T.O. Clutch and Brake Kit
3 - IH-473478-R2 - Throw Out Lever

Aftermarket
1 - IH-60071-C91 BEARING & L/COLLAR
I'm looking at this one
http://www.ebay.com/itm/Bearing-with...ZvK3sU97kmFqvg

The bolts look good and I have all the nuts and set screws for the pully.

Should I get a new snap ring? I haven't removed it yet, but will tonight. I assume if it feels tight and doesn't snap it's god to reuse?

P/N IH-473475-R1 Ring, Snap 2.197 O.D., for Pulley

How about the springs that go on the bolts

P/N IH-27452-D Spring, Compression

Anything else I should replace in regards to the PTO?

I already have a new thrust and wear button.