Must - cut - steel - !!
1 Attachment(s)
I just had to cut some steel,,, so I started,,,
A dozen pieces of 2" X 1/4" angle,,, 4 pieces of 1" round steel bar,,, 3 pieces of 1/4" flat,,, What should I build?? :bigthink: |
I'll take a CADdrag! :biggrin2:
|
1 Attachment(s)
Quote:
Hmmm,, how do you locate parts accurately,, when the corners are not square? CADDrag is a possibility,,, :bigthink: PROGRESS!! 42 holes are drilled,,, :biggrin2: |
Quote:
Mark height and draw line/clamp piece at top. Mark center line on top. Measure from top center to specific distance on bottom edge. ( if the part being fabricated is 42" wide, measure 21" off each side of centerline) Both sides should be the same measurement. |
3 Attachment(s)
Quote:
more welding than I was expecting,, or was it because it was 90 degrees when I was welding?? At least the paint is drying nicely with the 90 degree heat!! :biggrin2: The old trailer ended up getting the over-spray,,,so I just finished the paint on the trailer,,, |
CAD Plans picnic table. Love it :beerchug:
|
Quote:
|
No flames? I'm a little disappointed.
|
Quote:
Quote:
Quote:
I ordered bolts from Amazon, they will be here in a day or two,, I doubt the wind will blow this picnic table away!!?? :bigthink: I am planning on using the plastic decking wood,, :bigeyes: Do you think I will like that material? |
Quote:
|
All times are GMT -4. The time now is 03:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.