Elec PTO Bearing Repair
9 Attachment(s)
My brother has a MTD cc that the pto bearings went out of. Told him to ship me the pto and I would rebuild it. I don't remember his model, (which is funny, cause I just sold it to him) but it really doesn't matter. Almost all electric PTO clutches are made similar. Hope this helps someone!
Attachment 36681 Here is where they roll the metal down to hold one bearing in. You need to take a die grinder and grind these "tabs" off. Attachment 36682 The inner bearing had come completely apart, so I put the balls back in and tack welded them in place to I could press the old bearing out. Attachment 36683 Here are the "tabs" on the other bearing. One bearing only had 3, the other had.... um, lots. Attachment 36684 Not a great pic, but it shows the rasp bit I used and how the tabs look after grinding. Attachment 36685 All clean and disassembled. Old bearings laying out. Attachment 36686 One new bearing pressed in place. Attachment 36687 Now, take a sharp center punch and make new tabs to help hold the bearing in place. I don't always do this, and have never had a bearing come out. But, easy to do as added safety. Attachment 36688 The other bearing, with new tabs. Attachment 36689 Reassembled and ready to install! A new PTO is about $300. I got the bearings for about $25 a piece...... GOOD SAVINGS!! |
All times are GMT -4. The time now is 05:14 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.